Chlorine Free Spas
If you’re looking for healthier water sanitisation solutions, Waterco’s Spa Poppits has the largest range of nonchlorine and non-bromine chemical products on the market.
Poppits is one of the few products that have already been designed to sanitise spas using hydrogen peroxide to oxidise the bacteria and organic materials in the water.
Free of harsh chemicals and chemical by-products Poppits is the latest ultimate water management system for spa sanitisation.
Developed by Waterco, this system uses advanced oxidisation to purify spa water. Advanced oxidisation essentially raises the levels of active oxygen in the water, resulting in the removal of bacterial threats.
Endorsed by the National Asthma Council Australia, and the Asthma and Respiratory Foundation NZ as the
‘Sensitive Choice’ in pool and spa sanitisation, Poppits spa care range is specially formulated to be gentle on
skin, kind to asthmatics, and good for the environment.
3 Simple Steps to a Chlorine Free Spa
1. Heat And Read
Poppits Peroxsil Test Strip
Preheat water in spa to at least 26 degrees then, using Peroxsil395 test strip (swirl 3 times and line
up with colour indicators on test vial) check and record pH and alkalinity. It is important to make
the reading within 30 seconds for it to be accurate.
2. Balance Water
Adjusting the PH & Total Alkalinity with Poppits One-Step Prep
Based on the reading on the strip determine how much of the POPPITS ONE STEP WATER
PREP to add. When adding Poppits One-Step Water Prep to spa water, pour it slowly into the spa with the jets turned on.
Circulate water for 2 – 3 hours before moving to Step 3.
3. Sanitise Your Spa
Adding Poppits Peroxsil395 Pool & Spa Sanitiser
For Spas up to 3000 litres add 380mL / 1000 litres and circulate for 30 minutes.
For Swim Spas add 250mL / 1000 litres and circulate for 60minutes.